【Proteus仿真】【Arduino单片机】LCD1602-IIC液晶显示

文章目录

一、功能简介
二、软件设计
三、实验现象
联系作者

一、功能简介

本项目使用Proteus8仿真Arduino单片机控制器，使用PCF8574、LCD1602液晶等。
主要功能：
系统运行后，LCD1602液晶显示各种效果。

二、软件设计

/*
作者：嗨小易（QQ：3443792007）*/#include <Wire.h>
#include <LiquidCrystal_I2C.h>#if defined(ARDUINO) && ARDUINO >= 100
#define printByte(args)  write(args);
#else
#define printByte(args)  print(args,BYTE);
#endifuint8_t bell[8]  = {0x4,0xe,0xe,0xe,0x1f,0x0,0x4};
uint8_t note[8]  = {0x2,0x3,0x2,0xe,0x1e,0xc,0x0};
uint8_t clock[8] = {0x0,0xe,0x15,0x17,0x11,0xe,0x0};
uint8_t heart[8] = {0x0,0xa,0x1f,0x1f,0xe,0x4,0x0};
uint8_t duck[8]  = {0x0,0xc,0x1d,0xf,0xf,0x6,0x0};
uint8_t check[8] = {0x0,0x1,0x3,0x16,0x1c,0x8,0x0};
uint8_t cross[8] = {0x0,0x1b,0xe,0x4,0xe,0x1b,0x0};
uint8_t retarrow[8] = {	0x1,0x1,0x5,0x9,0x1f,0x8,0x4};LiquidCrystal_I2C lcd(0x27,16,2);  // set the LCD address to 0x27 for a 16 chars and 2 line displayvoid setup()
{lcd.init();                      // initialize the lcd lcd.backlight();lcd.createChar(0, bell);lcd.createChar(1, note);lcd.createChar(2, clock);lcd.createChar(3, heart);lcd.createChar(4, duck);lcd.createChar(5, check);lcd.createChar(6, cross);lcd.createChar(7, retarrow);lcd.home();lcd.print("Hello world...");lcd.setCursor(0, 1);lcd.print(" i ");lcd.printByte(3);lcd.print(" arduinos!");delay(2000);displayKeyCodes();}// display all keycodes
void displayKeyCodes(void) {uint8_t i = 0;while (1) {lcd.clear();lcd.print("Codes 0x"); lcd.print(i, HEX);lcd.print("-0x"); lcd.print(i+16, HEX);lcd.setCursor(0, 1);for (int j=0; j<16; j++) {lcd.printByte(i+j);}i+=16;delay(2000);}
}void loop()
{}